15 of 30
May 12, 2010
 
IDT Confidential
Software Write Protect
The TSE2002B3C has three software write-protection features, allowing the bottom half of the memory area (addresses 0x00 to 0x7F) to be
temporarily or permanently write protected.
Software write-protection is handled by three instructions:
SWP: Set Write Protection
CWP: Clear Write Protection
PSWP: Permanently Set Write Protection
The level of write-protection (set or cleared) that has been defined using these instructions, remains defined even after a power cycle.
Result of Setting the Write Protection
SWP and CWP
If the software write-protection has been set with the SWP instruction, it can be cleared again with a CWP instruction.
The two instructions (SWP and CWP) have the same format as a Byte Write instruction, but with a different Device Type Identifier (refer to the I
2
C
Operating Modes table). Like the Byte Write instruction, it is followed by an address byte and a data byte, but in this case the contents are all Don't
Care (refer to the Setting the Write Protection figure). Another difference is that the voltage, V
HV
, must be applied on the SA0 pin, and specific logical
levels must be applied on the other two (SA1 and SA2, as shown in the I
2
C Operating Mode table).
PSWP
If the software write-protection has been set with the PSWP instruction, the first 128 bytes of the memory are permanently write-protected. This
write-protection cannot be cleared by any instruction, or by power-cycling the device. Also, once the PSWP instruction has been successfully
executed, the TSE2002B3C no longer acknowledges any instruction (with a Device Type Identifier of 0110) to access the write-protection settings.
相关PDF资料
IPM6220ACAZ-T IC REG 5OUT BUCK/LDO SYNC 24SSOP
IR2170 IC CURRENT SENSE 600V 1MA 8-DIP
IR2171STR IC CURRENT SENSE 8SOIC
IR2172S IC CURRENT SENSE 8SOIC
IR2175STR IC CURRENT SENSE 0.5% 8SOIC
IR22771STRPBF IC CURRENT SENSE 16SOIC
IRU3073CQTR IC REG DL BCK/LINEAR 16-QSOP
ISL25700FRUZ-TK IC TEMP SWITCH MFET DRVR 10TQFN
相关代理商/技术参数
IDTTSE2002B3CNRG8 功能描述:IC TEMP SENS EEPROM DFN-8 RoHS:是 类别:集成电路 (IC) >> PMIC - 热管理 系列:- 标准包装:3,000 系列:- 功能:温度开关 传感器类型:内部 感应温度:85°C 分界点 精确度:±6°C(最小值) 拓扑:ADC(三角积分型),比较器,寄存器库 输出类型:开路漏极 输出警报:是 输出风扇:是 电源电压:2.7 V ~ 5.5 V 工作温度:-55°C ~ 125°C 安装类型:表面贴装 封装/外壳:SC-74A,SOT-753 供应商设备封装:SOT-23-5 包装:带卷 (TR) 其它名称:ADT6501SRJZP085RL7-ND
IDTTSE2002GB2A1NCG 制造商:Integrated Device Technology Inc 功能描述:IC TEMP SENS EEPROM DFN-8
IDTTSE2002GB2A1NCG8 制造商:Integrated Device Technology Inc 功能描述:IC TEMP SENS EEPROM DFN-8
IDTTSE2002GB2A1NRG 制造商:Integrated Device Technology Inc 功能描述:IC TEMP SENS EEPROM DFN-8
IDTTSE2002GB2A1NRG8 制造商:Integrated Device Technology Inc 功能描述:IC TEMP SENS EEPROM DFN-8
IDTTSI107C-100JE 制造商:Integrated Device Technology Inc 功能描述:IC HOST BRIDGE POWERPC 503FCPBGA
IDTTSI107D-100JE 制造商:Integrated Device Technology Inc 功能描述:IC PCI-PCI BRIDGE 32BIT 503BGA
IDTTSI107D-100JEY 制造商:Integrated Device Technology Inc 功能描述:IC PCI-PCI BRIDGE 32BIT 503BGA